Ocean Graphics

Ocean Graphics & Signs is a full service sign shop and design business located in East Hampton, NY. Since 1989. The Business was taken over in 2014 and overhauled by owner Will McLear to offer just about anything you can dream of with the highest of quality. With our combined experience, the Ocean Graphics & Signs staff has worked in the graphics & sign industry for over fifty years. Our staff are not merely sign makers, they are artists with years of experience in the industry. Our talented staff is here to help you from concept to completion and we are not satisfied until you are.

SeaDek Helm Station Pad

SeaDek Pad Large.jpg
SeaDek Pad Large.jpg

SeaDek Helm Station Pad

from 102.95

The SeaDek Anti-Fatigue Helm Station Pad provides the utmost of comfort while standing for long hours on the water. Made from closed-cell PE/EVA blended foam material, this soft yet durable, pad features 13mm foam that absorbs impact and an embossed surface with exceptional non-skid characteristics to provide safety and stability. The Helm Station Pad is available in a variety of colors to match any boat and is backed with our 3M™ pressure sensitive adhesive for an easy peel-and-stick installation.

Size:
Quantity:
Add To Cart

Helm Station Pad Installation Instructions

The only items you’ll need for your installation should be a sharp razor blade, masking tape, window cleaner and a clean cloth.

Thoroughly clean the area where SeaDek will be applied. We recommend using a cleaner that will not leave any residue. A glass cleaner used with a clean cloth or scotch-bright pad works well. Make sure the area is completely dry before applying the pad.

If there is any glue, grease, adhesive or other substances on the area that the pads are to be applied, mineral spirits followed by acetone may be used to remove them. Be sure to use a glass cleaner afterwards as suggested above. Again the surface must be completely dry before applying the pad.

If pads are being applied to a new boat right from the factory it is very important that all mold release is thoroughly removed from the boat surface. Be sure to check with the boat manufacturer before applying pads. Arrange the pad to the exact location to be covered and verify proper fit and placement. Once you are sure the pad is the right size and are happy with the location turn the pad over so that the paper backing is facing up. With a sharp razor, carefully cut the paper backing right down the center being careful not to cut into the pad. From the center, peel up each side a little to make sure the backing is completely cut all the way through.

Turn the pad back over and reposition the pad exactly where you want it to be installed. Firmly secure one side of the pad to the application area using two-inch masking tape.

Now lift up the untapped side of the pad with one hand and loosen the paper backing with the other. This process is a little easier if you have someone to help you out. Slowly and carefully pull up the rest of the backing while applying the pad to the platform. Use your hand to apply pressure to the pad to assure a firm bond between the pad and the platform. Now remove the tape from the other side of the pad and repeat the application process just like you did on the first side. Take time to press the entire pad into place with your hands especially around the edges of the pad.

You can watch a video demonstration of this installation HERE